Transitional Pull, 5-1/16" Center-to-Center, Brushed Nickel New Replace the inaccurate stock height

Replace the inaccurate stock height gauge on your portable planer and stop constantly using calipers to check stock thickness

Dot point is for cutting plastic materials used for stencils

With the Powermatic PM2000 table saw

and functionality make up this hand hammered copper round mirror with hand forged rivets

Its 3/8" width gives you a perfect balance of stability for straight cuts and maneuverability for gentle curves

Transitional Pull, 5-1/16" Center-to-Center, Brushed Nickel New Replace the inaccurate stock heightFrom Richelieu Hardware, the subtle contrast of curved lines on the handle and flared square feet will enhance furniture and cabinetry with a touch of sophistication. Specifications Center to Center measurement (distance between the drill holes): 5 1 16" (128 mm) Length (from left to right): 5 19 32" (142 mm) Width (top to bottom): 9 16" (14 mm) Projection (front to back): 1 11 32" (34 mm) Finish: Brushed Nickel, made of metal Mounting hardware is